How to configure new install to support Dolby Atmos?

At this time I had to uninstall K-Lite Codec and use Combined Community Pack to get my Atmos audio working again. How do you configure K-Lite to support Dolby Atmos because it does not do it at default install.

All you have to do is enable audio passthrough. Exact same as you have to do with CCCP.

Admin wrote:All you have to do is enable audio passthrough. Exact same as you have to do with CCCP.

You say that as if I have used K-Lite and know it's UI. Let's pretend I don't have a clue which I do not when it comes to K-Lite as I never have used it. Where in the UI do I enable it? I know CCP as I been using it well before the lats release which was beta. The K-Lite codec does not support it out of box for CCP to support I have to turn off the default mixing options and I have Atmos support. I don't know first thing about the UI for K-Lite UI so I have no idea what is different with the default settings. What do I need to change after a new standard install with MPC as player to enable Atmos.

Do you have a receiver? Because that is required for proper Atmos playback. Without a receiver it only decodes the TrueHD audio track and the Atmos layer is ignored. With passthrough the compressed audio is send to the receiver, instead of decoding it on the computer.

You can configure audio passthrough in one of three different places:
- In the installer on the audio settings page
- Codec Tweak Tool > Audio Output
- Or directly in LAV Audio Decoder settings